6001 or 12mm Wheelchair Bearings Removal and Installation Tool Kit

Description

This kit includes 6001 or 12mm Blind Bearing Puller/Extractor, Pin Punch, and 6001 or 12mm bearing press which allows you to remove and replace 6001 or 12mm bearings found in your wheelchair's front fork.
Product Information
Easy to Use
Cost Effective
Right Tool for the Job
Less Risk of Damage
Specialized Design
Description
If you want your wheelchair to move faster, go farther and smoother, then you have to maintain your wheelchair’s bearings.  Your wheelchair has bearings in three places: front caster, front fork, and rear wheels.  Most wheelchair manufacturers say you need to re-grease or change your front caster bearings yearly, and the forks and rear bearings as needed.  With the right tools, this is easy to do.  This kit includes 6001 or 12mm Blind Bearing Puller/Extractor, Pin Punch, and 6001 or 12mm bearing press which allows you to remove and replace 6001 or 12mm bearings found in your wheelchair's rear wheel hub, and for some wheelchairs, also in the front fork.
Features
Easy to use - this tool is designed specifically to remove bearings from wheelchair rear hubs or front forks
Cost-effective - you don’t have to buy an entire set of tools just for one or two sizes
The right tool for the job - most bearing tools are designed for bicycles or cars, not wheelchairs, so you have to make them work, which can damage your gear
Less risk of damage - specialized tool reduces the risk of damaging your hub or front fork as compared to using a flat head screwdriver
Specialized design - designed to accommodate recessed hub for rear wheelchair wheels
Problems this product solves:
Problem 1:
Automotive bearing pullers pull from the lip of the inside ring of the bearing, but a wheelchair hub axle sleeve can prevent the puller from grabbing the ring
Problem 2:
Bicycle bearing pullers are very expensive and do not come in imperial sizes.  Most US wheelchair rear wheels are 1/2” and some front forks are 1/2”
Problem 3:
Some wheelchair forks have recessed bearings.  Most bearing pullers are not long enough to use a wrench.
Used with the following wheelchair products:
Sunrise / Quickie Multi Position Fork
Sunrise / Quickie Multi Position Single Sided Fork
Fork Leg Suspension Fork for 12mm Axle
Numerous wheelchair forks that use a 6001 or 12mm ID bearings
Warnings:
Improper removal or installation of bearings can permanently damage casters, rear wheel hubs or caster stems.  Please use caution when using brute force.
Make sure you know the size and types of bearings on your wheelchair and buy the right sizes.
If you have questions or if we can help please .