Electric Bicycle BZ-4 (8) KT-V12L 8 12 Magnets Ebike PAS Pedal Assist Sensor

Description

Electric Bicycle Pedal 8 Magnets E-bike PAS System Assistant Sensor Speed Sensor
Model specifications：
8 Magnets
Lead mode：
three-wire
Connection:
3 pins SM plug or Waterproof plug
Model specifications: left model KT-D12
KT-D12 power-assistant sensor is with the characteristics of 12 signal outputs, fast power
response, good accuracy, strong water resistance,
high reliability, etc. Its installation and
removal is quick and easy. Sensor is divided into two models of left installation and right installation,
which can be installed in different locations to adapt to a variety of vehicle models.
Magnetic steel plate dimension:
Wire leading mode: three-wire system
Standard interface: SM-3Y
Left position installation instructions:
Installation of KT-D12L power-assistant sensor doesn’t need remove the crank,
and the sensor can be installed directly on the electric bicycle axle.
Fixing the sensor with a cable tie:
Installation of magnetic steel plate dimension:
Magnet plate assembly should plug the two pieces of magnetic steel plate
according to the following diagram, which is then fixed by using a circlip.
The assembled magnetic steel plate is as shown in the diagram.
Model specifications: left model KT-D12
KT-D12 power-assistant sensor is with the characteristics of 12 signal outputs, fast power
response, good accuracy, strong water resistance,
high reliability, etc. Its installation and
removal is quick and easy. Sensor is divided into two models of left installation and right installation,
which can be installed in different locations to adapt to a variety of vehicle models.
Magnetic steel plate dimension:
Wire leading mode: three-wire system
Standard interface: SM-3Y
Left position installation instructions:
Installation of KT-D12L power-assistant sensor doesn’t need remove the crank,
and the sensor can be installed directly on the electric bicycle axle.
Fixing the sensor with a cable tie:
Installation of magnetic steel plate dimension:
Magnet plate assembly should plug the two pieces of magnetic steel plate
according to the following diagram, which is then fixed by using a circlip.
The assembled magnetic steel plate is as shown in the diagram.